Table 2. Operating Characteristics
Unless otherwise noted: -40°C < T A < 85°C, 2.2 V < V DD < 3.6 V, Acceleration = 0g, Loaded output (1)
Characteristic
Symbol
Min
Typ
Max
Unit
Operating Range (2)
Supply Voltage (3)
Supply Current (4)
Supply Current at Sleep Mode (4)
Operating Temperature Range
V DD
I DD
I DD
T A
2.2
-40
3.3
400
3
3.6
600
10
+85
V
μ A
μ A
°C
Acceleration Range, X-Axis, Y-Axis, Z-Axis
g-Select: 0
g-Select: 1
g FS
g FS
±3
±9
g
g
Output Signal
Zero g (T A = 25°C, V DD = 3.3 V) (5), (6)
XY
Z (7)
Zero g (4)
Sensitivity (T A = 25°C, V DD = 3.3 V)
3g
9g
Sensitivity (4)
Bandwidth Response
XY
Z
Output Impedance
V OFF
V OFF
V OFF , T A
S 3g
S 9g
S,T A
f -3dBXY
f -3dBZ
Z O
1.551
1.23
-2.0
413.6
106
-0.0075
1.65
1.65
±0.5
440
117.8
±0.002
400
300
32
1.749
1.749
+2.0
466.4
129.6
+0.0075
V
V
mg/°C
mV/g
mV/g
%/°C
Hz
Hz
k Ω
Self Test
Output Response
X OUT , Y OUT
Z OUT
Input Low
Input High
Δ g STXY
Δ g STZ
V IL
V IH
+0.05
+1.0
V SS
0.7 V DD
-0.1
+2.5
+4.0
0.3 V DD
V DD
g
g
V
V
Noise
Power Spectral Density RMS (0.1 Hz – 1 kHz) (4)
n PSD
350
μ g/ Hz
Control Timing
Power-Up Response Time (8)
Enable Response Time (9)
Self Test Response Time (10)
t RESPONSE
t ENABLE
t ST
1.0
0.5
2.0
2.0
2.0
5.0
ms
ms
ms
Sensing Element Resonant Frequency
XY
Z
Internal Sampling Frequency
f GCELLXY
f GCELLZ
f CLK
6.0
3.4
11
kHz
kHz
kHz
Output Stage Performance
Full-Scale Output Range (I OUT = 3 μA)
Nonlinearity, X OUT , Y OUT , Z OUT
Cross-Axis Sensitivity (11)
V FSO
NL OUT
V XY, XZ, YZ
V SS +0.1
-1.0
-5.0
V DD –0.1
+1.0
+5.0
V
%FSO
%
1. For a loaded output, the measurements are observed after an RC filter consisting of an internal 32 k Ω resistor and an external 3.3 nF capacitor
(recommended as a minimum to filter clock noise) on the analog output for each axis and a 0.1 μ F capacitor on V DD - GND. The output sensor
bandwidth is determined by the Capacitor added on the output. f = 1/2 π * (32 x 10 3 ) * C. C = 3.3 nF corresponds to BW = 1507 Hz, which is
the minimum to filter out internal clock noise.
2. These limits define the range of operation for which the part will meet specification.
3. Within the supply range of 2.2 and 3.6 V, the device operates as a fully calibrated linear accelerometer. Beyond these supply limits the device
may operate as a linear device but is not guaranteed to be in calibration.
4. This value is measured with g-Select in 3g mode.
5. The device can measure both + and – acceleration. With no input acceleration the output is at midsupply. For positive acceleration the output
will increase above V DD /2. For negative acceleration, the output will decrease below V DD /2.
6. For optimal 0g offset performance, adhere to AN3484 and AN3447.
7.Product performance will not exceed this minimum level, however measurement over time will not be equal to time zero measurements for this
specific parameter.
8. The response time between 10% of full scale V DD input voltage and 90% of the final operating output voltage.
9. The response time between 10% of full scale Sleep Mode input voltage and 90% of the final operating output voltage.
10. The response time between 10% of the full scale self test input voltage and 90% of the self test output voltage.
11. A measure of the device’s ability to reject an acceleration applied 90° from the true axis of sensitivity.
MMA7341LC
Sensors
Freescale Semiconductor
3
相关PDF资料
KIT3376MMA7361LC KIT EVAL 3AXIS ANLG ACCELEROMETR
KIT3376MMA7361L KIT EVAL 1.56/6G 3-AXIS ACCELER
KIT3376MMA7368LC KIT EVAL 3AXIS ANLG ACCELEROMETR
KIT3376MMA7368L KIT EVAL 3AXIS ANLG ACCELEROMETR
KIT34844AEPEVBE KIT EVAL BOARD 10CH LED BACKLGHT
KIT3803MMA7660FC KIT EVALUATION FOR MMA7660FC
KITMMA9550LEVM KIT EVALUATION FOR MMA955XL
KITMMA955XLEVM KIT EVALUATION FOR MMA955XL
相关代理商/技术参数
KIT3376MMA7360L 功能描述:加速传感器开发工具 XYZ-AXIS ANALOG ACCELERO RoHS:否 制造商:Murata 工具用于评估:SCA3100-D04 加速:2 g 传感轴:Triple Axis 接口类型:SPI 工作电压:3.3 V
KIT3376MMA7361L 功能描述:加速传感器开发工具 3-AXIS ANALOG OUT 1.5g /6g Dev Kit RoHS:否 制造商:Murata 工具用于评估:SCA3100-D04 加速:2 g 传感轴:Triple Axis 接口类型:SPI 工作电压:3.3 V
KIT3376MMA7361L 制造商:Freescale Semiconductor 功能描述:3-Axis Analog Output Accelerometer Evalu
KIT3376MMA7361LC 功能描述:加速传感器开发工具 3AXIS Angl Accelero Eval Kit RoHS:否 制造商:Murata 工具用于评估:SCA3100-D04 加速:2 g 传感轴:Triple Axis 接口类型:SPI 工作电压:3.3 V
KIT3376MMA7361LC 制造商:Freescale Semiconductor 功能描述:Analog Output Accelerometer Evaluation B
KIT3376MMA7368L 功能描述:加速传感器开发工具 3-AXIS ANALOG OUT 1.5g Dev Kit RoHS:否 制造商:Murata 工具用于评估:SCA3100-D04 加速:2 g 传感轴:Triple Axis 接口类型:SPI 工作电压:3.3 V
KIT3376MMA7368LC 功能描述:加速传感器开发工具 3AXIS Angl Accelero Eval Kit RoHS:否 制造商:Murata 工具用于评估:SCA3100-D04 加速:2 g 传感轴:Triple Axis 接口类型:SPI 工作电压:3.3 V
KIT33794DWBEVM 功能描述:位置传感器开发工具 33794DWB ODS-NITRON EVAL RoHS:否 制造商:Microchip Technology 工具用于评估: 接口类型: 工作电压: